Adjusting Rod Rig holder spacing

To adjust the lateral spacing of the Rod Rig rod holders, locate the thumb screw in the center of the rod mount. Turn the screw counter-clockwise a few rotations to loosen it, slide the holder to your desired position, and then tighten the screw clockwise to secure it in place.



Once the thumbscrew is loosened, you can easily slide the rod carrier left or right along the main extrusion with minimal effort. We recommend leaving a few inches of space between each rod carrier to ensure easy loading and unloading of your rods from the Rod Rig system.



Note: If you slide the rod carrier to the end of the extrusion where the telescoping sections meet, you can fully remove the carrier from the main horizontal extrusion.

Once you have positioned the rod carrier to your preference, tighten the thumb screw on each unit until it is finger-tight to secure it firmly in place.